Schoeps CMC 1 KV, XLR, Microphone Amplifier
The CMC 1 is our new, small Colette microphone amplifier, about one-third the length and 53% lighter than the CMC 6.
Accessories for this and other products can be found in the category "Accessories".
The CMC 1 is our new, small Colette microphone amplifier, about one-third the length and 53% lighter than the CMC 6.
It is compatible with all components of the Colette system and can be used in place of the CMC 6 without compromise, for all applications in which the size and weight of the microphone play a role.
At SCHOEPS, “uncompromising miniaturization” means that the electrical characteristics of the CMC 1 are equal to, or even better than, those of the CMC 6. Through modern electronic design, these outstanding electrical properties have been achieved.
ORDER NUMBER: No. 132013 CMC 1 K, permanently attached laterally outgoing cable (2m cable XLR3M), incl. SGC, Premium Case and magnetic accesories
Features:
· Complete alternative to the renowned CMC 6
· Fully compatible with all existing MK capsules and Colette active accessories such as the CUT 60 and RC tubes
· Suitable mounting accessories are already available, such as the CINELA E-OSIX-CMC1U and the Rycote INV-6 elastic suspensions.
· high maximum SPL: 135 dB-SPL with the MK 4 (0.5% THD or less)
· very low current consumption: 2.0 mA at 48 Volts
· operates on 48 V or 12 V phantom power, reliable operation even if powering is somewhat marginal
· very high immunity from RF interference with the SCHOEPS RFI Shield; high immunity to cable-induced hum and other interference (field tested with Audio Limited A 10, etc.)
· flat frequency response
· very low distortion constant output impedance across the audio frequency range
· balanced, direct-coupled, class-A output circuit
· output is filtered in the ultrasonic range to prevent interference, e.g. from camera autofocus
TECHNICAL SPECIFICATIONS:
Frequency range: 20 Hz-20 kHz
Sensitivity: see corresponding capsule
Maximum output voltage: 1,8 V (5 dbV) with 1 kΩ load
Maximum sound pressure level (THD < 0.5 %): 135 dB-SPL (P48) with MK 4
131 dB-SPL (P12) with MK 4
Low cut filter: 20 Hz, 12 dB/oct
Output impedance: 50 Ω +/- 1 Ω (8 Hz - 50 kHz)
Minimum recommended load impedance: 1 kΩ
Common mode rejection ratio (at 1 kHz): > 55 dB
Maximum cable length : > 400 m / ~1300 ft
SCHOEPS RFI Shield: Yes
Powering standard / Valid range: P48 / 30-52 V
P12 / 11-13 V
Current consumption: 2 mA (P48)
3 mA (P12)
Output: XLR-3M, analog, 1 channel
Length: 36 mm / ~1.4"
Diameter: 20 mm / 0.8"
Weight : 36 g / 1.3 oz
Surface finish: matte gray
custom color: nickel, chromagreen